Your emergency brake is an ext important 보다 you can think. Here is how to change your emergency brake on your Ford F-150 or super Duty.

You are watching: How to replace parking brake cable on ford f150


This article applies to the Ford F-150 (2004-2014) and also F-250 supervisor Duty (2005-2014).

If your emergency brake isn’t working appropriately or is just plain worn out, this aren"t tough fixes. This repair will certainly take you the better part of an afternoon. For those who are somewhat mechanically inclined, it have to only take it an hour or two.

*


Materials Needed4mm retainer pinBrake lubricantSocket/wrench setPhillips head screwdriverEmergency brake kitJack and also 2 jack standsTire ironRubber mallet

Step 1 - Prepare the truck

Block the front wheels so the truck can’t role in any direction.Loosen the lug nuts on the rear wheels.Using the jack, raise the rear end of the truck enough to obtain the jack was standing underneath the rear axle, and remove the behind wheel on every side.
*
Figure 1. Raise the truck.

(Related Article: how to readjust a tire - cg-tower.com)

Step 2 - inside the truck

Place your truck in neutral.Remove left A-pillar lower trim panel (pull earlier and it will certainly unclip itself).Have one assistant traction on the intermediate parking brake cable until the parking brake rotating sector regulate stops.While the assistant is hold the cable, insert the 4mm retaining pen to relax the parking brake cable tension (as displayed in figure 2 below).
*
Figure 2. Relax the parking brake cable tension.

Step 3 - at the behind axle

Disconnect the parking brake cable in ~ the cable-to-cable union making use of the suitable sized wrench or socket.Remove the rear brake disc.
*
Figure 3. Behind brake disc.Remove the brake shoe adjuster screw and brake shoes adjuster screw spring making use of the Phillips head screwdriver.Remove both brake shoe organize down springs, pins, and finally the brake shoe retracting spring.Remove the brake shoe.
*
Figure 4. Spring and also shoe locations.Using the brake lubricant, lubricate the brand-new parking brake shoes wherein they will certainly make call with the wear pad.Install the new shoe and ensure the it is focused on the hub.
*
Figure 5. Brand-new shoe installed.

See more: How Much Does A Hercules Beetle Weigh ? Hercules Beetle

Step 4 - Finishing up

Re-install all removed screws, springs, and pins in the reverse order they come off.Using the emergency brake shoe adjuster wheel, change the parking brake shoe clearance to .66mm.Repeat procedure for the opposite side of the truck.Reattach parking brake cables at the cable-to-cable unions.Remove the 4mm retaining pin.Reinstall the trim panel.Reinstall the wheels.Test the parking brake come ensure that works. You have the right to test easily by parking on an incline, setting the brake, and also then putting the van in neutral. If there is no roll, the parking brake is set correctly. If the truck rolls, you may need to inspect the parking brake shoe clearance again.

Related Discussion and also Site