Replacing door pins on a Chevy Silverado is not a very an overwhelming process, although the door is an extremely heavy and awkward. One person can do it, but a helper to assist in supporting the door renders the job much easier. When the door pins wear out, the door will not line up with the door striker properly. The actual pin isn"t the trouble as lot as the brass bushings in the hinge.

You are watching: How to change door pins on a 2000 chevy silverado


Open the door every the way, and put the window down. Location the jack under the door and also center that so the door will be balanced relatively well when removed. The is a good idea to placed a towel or something similar on the foot the the jack so that does not damages the repaint on the bottom the the door.


Raise the jack come touch the bottom of the door, then save lifting till the door is level. That is usually about an customs or two. Punch the pins upward and out the the hinge using the hammer and also drift. Usage a helper to support the door at this point so the does not fall off the jack as soon as pulled back.


Pull the jack handle, and also bring the door the end just enough to separate the door hinge indigenous the framework hinge. At this point, the door"s prior edge will certainly lean against the former fender if there is no helper. If you space careful and also have the jack centered, the door have to stand up on its own. Be cautious not to scrape the repaint on the fender.


Remove the brass bushings from the door hinge. Sometimes they will come out with small effort and also other times they it seems to be ~ to be welded in. Insanity them native the bottom upward, making use of the drift. If castle fail to come out, usage the chisel come tap the head of the bushings till they break, in ~ which allude they will come out. They have splines that organize them in the hinge.


Install the new bushings. This bushings are not strong, so tap lock in gently. Center the drift therefore the edges execute not break. One bushing go in the top of the hinge top top the door encountering down. The second bushing is a tiny trickier. It must go top top the bottom of the door hinge facing up. If the goes in tight, that"s good; however, this bushing may not stay in. In this situation, organize the bushing with a finger until it is in between the section of frame hinge where it will certainly not loss out or you have the right to glue it.

See more: Did You Know How To Put Window Back On Track ? How To Put Electric Window Back On Track


Move the door in, insert the door hinge in the frame hinge and also line up the holes. Insert the bottom pin first, and shot to heat up the splines under the head of the pin v the splines cut by the last set of pins. Use the drift to hammer them in with just enough force to drive them down. Carry out not walk crazy v the hammer. You carry out not desire to bending the hinge; simply use tiny taps till the pin is sit to the head. Carry out the very same with the peak hinge.