Almost any type of driver can perform this ~ above their very own if they have actually the crucial materials and hydraulic jacks. Review on to learn exactly how to adjust the oil on your Civic.


This article uses to the Honda civic (1992-2000).

You are watching: 2001 honda civic oil filter location

Honda recommends an oil readjust when the maintain light comes on, or after ~ one year—whichever comes first. In tough driving problems with a lot of stop-and-go traffic, the maintenance light will come top top after around 6,000 miles, which suggests 15 percent the oil life remaining.

*

Materials NeededHydraulic jacks and also jack stands17 mm box finish wrench5W-30 engine oil (4 quarts)FunnelOil drainpipe plug gasketOil drain panOil filter wrenchRagsEngine flushEngine restore

Step 1 – start the engine and jack increase the car

Warm increase the engine to the operation temperatures. This helps to suspend any type of engine contaminants in the old oil. When the engine is warmed up, prepare and also position the hydraulic floor jack and three ton jack stands. Then, turn off the engine.

To jack up your car, very first you will have to pull the parking brake.Underneath the front passenger"s side, place a jack under the jacking suggest of the frame, which is also called the pinch weld (the thicker metal part just behind the front wheel).Lever the jack till you have sufficient room to job-related comfortably under the car.Place a jack was standing under the pinch weld behind the jack.Slowly lower the car onto the jack stand. Leaving the hydraulic floor jack underneath the framework for added support, and be sure it is not lifting the car above the jack stand.Repeat these procedures with the driver"s side of the car.
*
Figure 1. Hydraulic floor jack under the pinch weld.
*
Figure 2. Insert the jack stand alongside the hydraulic jack.

(Related Article: just how to Jack up Your public - cg-tower.com)

Step 2 – drain the old oil

Remove the oil lid on optimal of the engine. This will assist the old oil to completely drain.Underneath the automobile (closer come the engine 보다 the transmission) is a 17 mm hex oil drainpipe plug, encountering the rear of the car. Ar the oil pan under this plug.Use a 17 mm box finish wrench to loosen the drainpipe plug 3/4 of a turn.Remove the drainpipe plug through hand, and also then allow the oil to drainpipe into the pan.
*
Figure 3. Eliminate the oil drainpipe plug.
Pro Tip

Observe the oil for shiny specks. Steel flakes in the oil suggests a serious troubles with the internals of her engine.


Step 3 – Clean the oil drainpipe plug and replace gasket

While the oil is draining, wipe turn off the drainpipe plug through a clean rag. Then, remove the old drainpipe plug gasket.Place a new gasket onto the oil drainpipe plug, and also make certain it fits around the plug threads.Once the oil has slowed down to a drip, wipe off the area around the drainpipe plug with a clean rag.Apply a light coat of fresh engine oil come the threads of the oil drain plug to ensure the seals properly.Using the box end wrench, re-install the oil drain plug tightened come a snug fit.
*
Figure 4. Connect a new oil drainpipe plug gasket.
Pro Tip

Alternatively, you can use a talk wrench come verify that the plug is tightened come its correct specification.


Step 4 – lower the car and replace oil filter

Jack up the vehicle with the hydraulic jack, so the is no longer resting ~ above the jack stand. Remove the jack stand, then gradually lower the automobile to the floor.

To change the oil filter, very first locate it. Top top the firewall next (halfway under the engine block) is whereby the oil filter is located.Using the oil filter wrench, remove the old oil filter by rotating clockwise.Before re-installing the brand-new oil filter, apply a light coat of fresh oil roughly the rubber ring and also threads come ensure the seals properly.Install the new oil filter and tighten it to a snug fit.
*
Figure 5. Removed the jack stand.Figure 6. Apply fresh engine oil to the oil filter.Figure 7. Install the new oil filter.

Step 5 – to water in the new oil

On height of the engine, eliminate the oil filter cap.insert the funnel into the filler hole to stop spills.Pour 4 quarts the 5W-30 engine oil (preferably full-synthetic) right into the funnel.
*
Figure 8. Remove the oil filler cap.

See more: How Many Ounces In 1/16 Of A Pound Crossword Clue, Clue: 1/16 Of A Pound

*
Figure 9. Pour in the new engine oil.
*
Figure 10. Inspect engine oil level.
Pro TipsLook in the owner"s hand-operated for the acceptable weights of engine oil for her car.Refer to the orange oil dipstick to identify the oil level in the engine. The height of the crosshatched area is the maximum amount of oil, when the bottom the the crosshatch is the minimum.Take your old oil and also oil filter come a recycling facility. Most auto components stores and also repair shops expropriate these in ~ no charge.